Showing posts with label copter. Show all posts
Showing posts with label copter. Show all posts

Wednesday, November 12, 2014

OLH-360 update I




A quick status update on the FPV 250 Style octocopter I'm currently building.


This mini octocopter called OLH-360 will have a low hung cage that is connected to the frame by anti vibration rubbers. This low hung cage will house all electronics, except the motor power circuit. (BAT, ESC, PDB)

All Power hungry electronics are mounted on top of the octocopter.
PDB (power distribution board) mounted on top in the center of the frame. Battery will be mounted on top of this PDB. ESC en motors will also be mounted on top of the arm. This will maximize the distance between the FC boards magnetometer and the EMF caused by high currents (MOTOR/ESC/BATT).


Weight is building up. When I would use 15gr brushless outrunners with 6a ESC and a 3000mAh 3cell Lipo I'll end up at 950-1000grams AUW. Depending on the performance of the motor I would get a trust to weight ratio somewhere between 2:1 and 2.5:1.




Sunday, November 02, 2014

FPV 250 style OCTO-Copter (3D PRINT)

Something else now.

My next project is a small OCTO copter. Why? Because I would like to have a multirotor that is able to continue flight when one engine fails.

For this purpose I already had started my Y6 project. But I did not really like the way a Y6 flies. A Y6 is pitch sensitive when you change yaw. A second factor is the efficiency loss on the bottom motor/prop. A the last factor to discontinue my Y6 project was the size of it. I found it to be to large to fly in my backyard.


So a new project is born. This is HK FPV 250 style OCTO-Copter. This octo frame is 3D printed with PLA and weighs only 135 grams. Motor to motor distance is 36cm.

To goal is to mount the HK FPV 250 low hung kit on this frame with all electronics inside. Depending on the weight I will then choose a motor/esc/battery combination. Maximum prop size on this frame is 5 inch.

I'll call it the OLH 360 (octo low hung - 360 mm)